The Advantages of Sandblasting for Custom Metal Fabrication Project 

Doing a custom metal fabrication project is far more difficult than making an ordinary metal portion. The measurements need to be accurate and all of the methods and steps have to be carefully picked (that includes the type of finish which would suit the portion being done). In addition to that, it has been known that sandblasting in Columbus OH provides a distinct benefit for most metal fabrication projects. 

Custom Metal Fabrication


Sandblasting is a term that is used within metallurgical industries to refer to a series of actions of propelling small and fine grains of sand at a very high rate in order to etch or clean a surface area. As a matter of fact, there are a lot of kinds of granular materials available for the procedure and each has their own sets of properties, and benefits offered when utilized for designated kinds of metals and fence installation costs. 


There are a lot of reasons why you must use this method for your next metal job, including: 

It removes rust, oil and mill scale that have a possibility to form on the portion of the metal parts which have been newly manufactured.  

Manually cleaning and removing stains can take you hours which also requires a lot of your effort. Nevertheless, with the use of this technique, sandblasting, it can speed up the whole procedure and takes less effort out of you. 

The same materials can be utilized a number of times for sandblasting and a reusable asset. Hence, this helps lower down the cost of the entire project, making it a more economical choice for you. 

It is a highly effective procedure of removing dirt and old paint on the surface before applying a new coat of paint. It is also very efficient on taking down hard sticking dirt particles which may be very difficult to remove manually, and this benefit is very helpful you start your paint job. 

A lot of other kinds of dangerous surface contaminants are being removed during the procedure. This includes oil spots and dirt, which can be removed easily in hard to reach surfaces. Using your bare hands to remove stains in hard to reach surfaces is not even an option. 

There are a lot of options present for the materials to be used in sandblasting process. The options may range from substances that are biodegradable like walnut shells, to a special steel grit. Therefore, you can choose your option phoenix bus company that best suits you, based on your attitude and personal needs toward the project. 


Since almost all of the surface stains and oxidation are being removed on the procedure, avoid leaving the metal vulnerable and exposed to the moisture present in the air. Ensure that the product is always kept within dry places right after being sandblasted.  

Also, be very careful getting anything inside your orifices or eyes during the whole course of the project most especially when you are working with tiny particles.  

Therefore, there is no doubt that this procedure brings you so many benefits as long as you just have to follow the steps in sandblasting properly and take necessary precautions. 

Leave a Reply

Your email address will not be published. Required fields are marked *